The revolutionary 3D-Flosser
|
Now you can floss all teeth with just one bite!
And with the new 3D-Flosser 2.0, introduced in June 2019, we further perfected the design and made it super-easy to use for everyone. Flossing is extremely important - no wonder all dentists do it all the time. One should do it daily. Dentists often say: "You must floss all teeth you want to keep!". But it always was a complicated, time-consuming, and even dangerous labor - until now. The tailored 3D-Flosser positions floss exactly where it needs to be between all your teeth. Floss is positioned in all places where it needs to be - behind your last molars too. You don't have to learn a special cleaning technique - you can floss effortlessly now. |
Tailored 3D-Flosser 2.0
|
|
The 3D-Flosser makes flossing easy and fun and thus enhances tooth hygiene dramatically - it has been proven in longterm tests since 2013.
The 3D-Flosser perfectly cleans 2-3 mm deep into the region between gums and teeth (the "Gingival Sulcus"): exactly how it is recommended by dentists. And exactly like it is normally done by hand. Thus perfect flossing just takes a few seconds now. |
|
How to use the 3D-Flosser:When biting into the floss you can slightly move teeth left/right, to feel/find the entries of the floss between your teeth. By biting into it the floss moves between all your teeth until the gumline is reached, thus removing a lot of dirt already. Grinding and biting left/right and forward/backwards a bit now moves all the rest out.
Remove the floss from your teeth ("bite out") like shown in the video, while holding the flosser firm, or pressing downward while biting out the upper jaw, and upwards for the lower jaw. After flossing you wash the used floss under water, then let it dry. Before the next use you pull the dry floss out (because it is much easier to do when dry): it just takes few seconds, and you are ready for the next flossing! To pull out the used floss: unlock the flossrolls (push the white cylinder to the left), pull a handwidth out with the pullring, lock the flossrolls (push cylinder to the right), then pull floss completely out, secure it, and shear off the used floss. |
|
|
|
3D-Flosser 2.0
|
|
How long does the 3D-Flosser last?
- There is enough floss in it for over 400 uses. After that you can change the floss-rolls, or you purchase a completely new replacement 3D-Flosser for just 49.- How to purchase Buy Questions? Contact us at: office@blizzident.com |
Tailored 3D-Flosser 2.0
|
|
In 5/2020 we introduced a new product that
- is totally easy to use - cleans even better than the tailored brush - is much less expensive The CleaningSponge. |
|